<rp id="dmenz"></rp>
<button id="dmenz"></button>

<dd id="dmenz"><pre id="dmenz"></pre></dd>

<button id="dmenz"><acronym id="dmenz"><cite id="dmenz"></cite></acronym></button>

<li id="dmenz"><acronym id="dmenz"></acronym></li>

<form id="dmenz"><tr id="dmenz"><kbd id="dmenz"></kbd></tr></form>
產品中心 Products center

首頁 > 產品中心 > 其它 > EEPROM

AT24C02

Device Selection Tble

 

Part Number

VCC Range

Max. Clock Frequency

AT24C02

1.8-5.5

400KHz

Note 1: 100 KHz for Vcc=1.8V


Features

  • Single supply with operation down to 1.8v

  • Low-power CMOS technology:

  • 1 mA active current, typical

  • 1 μA standby current, typical(l-temp)

  • Organized as 1 block of 256 bytes (1×256×8)

  • 2-wire serial interface bus, l2CTM compatible

  • Schmitt Trigger inputs for noise suppression

  • Output slope control to eliminate ground bounce

  • 400 kHz (24C02) compatibility

  • Self-timed write cycle (including auto-erase)

  • Page write buffer for up to 8 bytes

  • Hardware write-protect for entire memory

  • Can be operated as a serial ROM

  • Factory programming (QTP) available

  • ESD protection>2000V

  • 1,000,000 erase/write cycles

  • Data retention>100 years

  • 8-lead PDIP, SOIC ,TSSOP packages

  • Pb-free finish available


Description

The 24C02 is a 2Kbit Electrically Erasable PROM, The device is organized as one block of 256 x 8-bit memory with a 2-wire serial interface. Low-voltage design permits operation down to1.8V, with standby and active currents of only 1μA and 1mA, respectively. The 24C02 also has a page write capability for up to 8 bytes of data. The 24C02 is available in the standard 8-pin PDIP, surface mount SOIC, TSSOP package.

1.png

聯系我們Content us

在線客服

深圳市華芯邦科技有限公司(總部)

郵箱:rubyli@hotchip.com.cn

電話:0755-88844476

地址:深圳市龍華區民治街道民塘路328號龍華區數字創新中心B座25樓

hx-wechat 華芯邦微信公眾號
翘臀后进呻吟喷水的少妇_youjizzzz_久久久久亚洲av成人片_白洁高义张敏
<rp id="dmenz"></rp>
<button id="dmenz"></button>

<dd id="dmenz"><pre id="dmenz"></pre></dd>

<button id="dmenz"><acronym id="dmenz"><cite id="dmenz"></cite></acronym></button>

<li id="dmenz"><acronym id="dmenz"></acronym></li>

<form id="dmenz"><tr id="dmenz"><kbd id="dmenz"></kbd></tr></form>